Robe CLUBSPOT 160 CT Specifications download pdf (Page 6)

4.Installation

4.1Fitting/Exchanging the lamp

DANGER !

Install the lamp with the device switched off only.

Unplug from mains before !

To insert the lamp CDM-SA/T 150/942 open the small lamp cover at the rear of the head (see the drawing) by

loosening the 4 screws „W, X,Y, Z,” on the lamp cover.

Gently pull out the lamp assembly.

If changing the lamp, remove the old lamp from the socket. Insert the lamp to the socket.

Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is not designed

for.

Damages caused by non-observance are not subject to warranty. Please follow the lamp manufacturer‘s notes!

Do not touch the glass-bulb bare hand during the installation! Make sure that the lamp is installed tightly into the

lamp holder system.

Reinsert the lamp assembly and tighten 4 screws again.

Before striking the lamp, reset the "LAti/rSEt" and "LASt/rSEt"counters in the "InFO" menu on the control

panel, by pressing the [ ] and [ ] buttons in one time and then confirming with the [ ] button.

Do not operate this fixture with opened housing-cover!

4.2Lamp adjustment

The CLUBSPOT 160 CT lampholder is aligned at the factory.

Due to differences between lamps, fine adjustment may improve

light performance.

Strike the lamp, cancel all effects, open the shutter and set

the dimmer intensity onto 100 % and focus the light on a flat

surface (wall) or use function "LAAd" in the Special

functions .

Center the hot-spot (the brightest part of the beam) using the 3

adjustment screws „A, B, C”. Turn one screw at a time to drag

the hot-spot, diagonally across the projected image. If you cannot

detect a hot -spot, adjust the lamp until the light is even.

screws "X,Y,Z W"

Lamp cover:

screws "A, B, C"

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

No comments

Robe CLUBSPOT 160 CT Specifications Page 6