Robe Color Wash I200E User Manual download pdf (Page 28)

Dimmer Curve - Select desired dimmer running.

Curve 1 Curve 2

CMY + CTF Curve - Select desired CMY lters + conversion temperature lter running.

Curve 1 Curve 2

Temperature Unit --- Select this menu in order to display xture temperatures in °C or °F.

Default Settings - Select this option to reset all xture personalities to the default values.

9.4 Lamp On/Off

Use this option in order to switch on/off the lamp. It is also important to note, that the lamp is cold restrike type, that means,

that it has to be cold before striking.

9.5 Test sequences

Use this menu to to run a special demo-test sequences without an external controller, which will show you some possibili-

ties of using ColorWash 1200E AT.

Mode 1 - This mode is suitable for projections on the wall, ceiling or ground without any head movement.

Mode 2 - This mode uses all ColorWash 1200E AT functions including pan/tilt movement and therefore is good

for

a complete introduction of the xture.

9.6 Manual mode

Presetted Effects - Select this menu to call up presetted positions of channel effects.

Manual Effect control - Select this menu to control channels by control elements on the control board.

9.7 Stand-alone setting

Use this menu to set options for stand-alone mode as a selection of the playing program,programming and modifying

current programs.

Music Trigger - Select this function to enable the sound control of the running programs via the built-in microphone.

Presetting Playback - This function allows you to select the program which will be played in the

stand-alone mode after switching the xture on.Selected program will be played continuously in a loop.

Disabled - The option disables „Presetting playback” function.

Test Program - The option will start built-in test program.

Program 1 - The option will start created program No.1

Program 2 - The option will start created program No. 2

Program 3 - The option will start created program No. 3

Note: If the xture operates in the controller mode (DMX controller is connected) and any program from this menu is

selected, in this case the xture will not respond to the DMX controller after switching on and will play selected program.

Playing program -Select this menu to run a built-in program or the 3 freely-programmable programs in a loop.

Test Program In Loop - The option starts built-in test program.

Program 1 In Loop - The option starts created program No. 1

Program 2 In Loop - The option starts created program No. 2

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

No comments

Robe Color Wash I200E User Manual Page 28