Robe Robin 600 LEDWash Specifications download pdf (Page 9)

3.4 Rigging the xture

The installation of the xture has to be built and constructed in a way that it can hold 10 times the weight for 1

hour without any harming deformation.

The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.

This secondary safety attachment must be constructed in a way that no part of the installation can fall down if

the main attachment fails.

When rigging, derigging or servicing the xture staying in the area below the installation place, on bridges,

under high working places and other endangered areas is forbidden.

The operator has to make sure that safety-relating and machine-technical installations are approved by an expert

before taking into operation for the rst time and after changes before taking into operation another time.

The operator has to make sure that safety-relating and machine-technical installations are approved by an

expert after every four year in the course of an acceptance test.

The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled

person once a year.

The xture should be installed outside areas where persons may walk by or be seated.

IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)

calculating working load limits, installation material being used, and periodic safety inspection of all installation

material and the projector. If you lack these qualications, do not attempt the installation yourself, but instead

use a professional structural rigger. Improper installation can result in bodily injury or damage to property.

The xture has to be installed out of the reach of people.

If the xture shall be lowered from the ceiling or high joists, professional trussing systems have to be used. The

xture must never be xed swinging freely in the room.

Caution: Fixture may cause severe injuries when crashing down! If you have doubts concerning the safety of

a possible installation, do not install the moving head!

Before rigging make sure that the installation area can hold a minimum point load of 10 times the xture’s

weight.

When installing the device, make sure there is no highly inammable

material (decoration articles, etc.) in a distance of min. 0.5 m.

CAUTION!

Use an appropriate clamp to rig the xture on the truss.

Follow the instructions mentioned at the bottom of the base.

Make sure that the device is xed properly! Ensure that the

structure (truss) to which you are attaching the xtures is secure.

The xture can be placed directly on the stage oor or rigged on a truss without altering its operation characte-

ristics .

For securing a xture to the truss install a safety wire that can hold at least 10 times the weight of the xture.

Use only safety wire with screw-on carabine. Pull the safety wire through the carrying handles and around the

truss as shown on the pictures below.

Note: If the safety wire is too long, whip it several times around the trusss in order to attach the xture tight.

In case of an accident, the way of the falling xture will be short.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 41 42

No comments

Robe Robin 600 LEDWash Specifications Page 9