Robe DMX Control 24 Pro Specifications download pdf (Page 7)

4. Installation

4.1.Sound-control

The sound-control either works via the ¼” mono jack-socket or the built-in microphone.

If the DMX CONTROL 24 PRO CT is supposed to work via a soundsignal at the Audio In-socket, connect the ¼“

jack socket with the soundsignal of your headphones output or a second adjustable output (if existing) of your

mixer, or with the loud-speaker output of your amplifier.

Tip: Data +

Sleeve: Ground

Caution: Never connect the sound input with the DMX-output, as this will destroy the electric (DMX-driver).

4.2.DMX-512 connection with the projectors

Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with the

fixture or one fixture with another.

Occupation of the XLR-connection:

DMX - output DMX-input

XLR mounting-socket: XLR mounting-plug:

If you are using the standard controllers, you can connect the DMX-output of the controller directly with the DMX-

input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other DMX-outputs, you

need to use adapter-cables.

Building a serial DMX-chain:

Connect the DMX-output of the DMX CONTROL 24 PRO CT with the DMX-input of the nearest projector. Always

connect one output with the input of the next fixture until all fixtures are connected.

Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 ohms resistor

between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

1 - Ground

2 - Signal (-)

3 - Signal (+)

1 - Ground

2 - Signal (-)

3 - Signal (+)

1 2 3 4 5 6 7 8 9 10

No comments

Robe DMX Control 24 Pro Specifications Page 7