Robe Spot 575 XT Specifications download pdf (Page 25)

Lamp adjustment

This function can be used when you make the fine adjustment of the lamp.If you select "LAAd" pressing by

[Enter]-button ,all effects will be canceled,shutter will be opened and the dimmer intensity will be set onto 100%.By

using the options "PAn, tilt,Foc" you can focus the light on a flat surface (wall) and perform the fine lamp

adjustment.

Fixture code

The option contains identification code (1-9999) for the fixture, which is used for the master/slave operation.

Adjusting the default positions. of colour, gobo and effect wheels

By this function you can calibrate and adjust the colour,gobo and effect to their standard/right positions. Use the

[Up] and [Down] keys to browse through the adjusting menu - the display shows step by step these messages:

" PAn, Tilt,FPAn,FTilt, SPEd,Func,Col,SGob, EFEC, rotP,rGob, rotG,Iris, Foc, Stro, dimr, FCAL" by which

you can adjust the fixture to the required/desired position (0-255) before the function calibration. Then when the

positioning is finished use the last "FCAL" function (Fixture calibration).

1. Calibration via the control board

Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Col, SGob,EFEC,

rGob, rotG," for very smooth function calibration. Select one of them, press [Enter] and use the [Up] and [Down]

keys in order to adjust their right value from 0 to 255. Then press [Enter] to confirm or [Menu] to cancel and return

to the menu. This can be repeated for each calibration parameter if it is required. When the calibration is finished,

it is necessary to use the "ArES" function in order to write the calibration values to the memory (EPROM) and to

make a reset in order to check the newly adjusted positions of the colour, gobo and effect wheels. When the reset

of the fixture is finished, the display will show the "FCAL" message. Press [Enter] to repeat the calibration or

[Menu] to return to the "AdJ" menu.

2. Calibration via the external controller

Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Col, SGob,EFEC,

rGob, rotG," - calibration parameters. Select one of them and press [Enter].

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

No comments

Robe Spot 575 XT Specifications Page 25