Robe COLORSPOT 170 AT Specifications download pdf (Page 11)

Fixation via the Omega holders

1. Screw the clamps (1) to the omega holders (4) through the hole in the holders.

2. Fasten the omega holders on the botton of the base by inserting both quick-lock fasteners (3) into the holes of

the base and tighten fully clockwise.

3. Fasten the safety-rope (2) through the two apertures on the bottom of the base and over the trussing system.

1-Clamp

2-Safety-rope

3-Quick-lock fastener

4-Omega holder

4.5 Connection to the mains

Verify the power supply settings before applying power!

If you wish to change the power supply settings,see the chapter Appendix.

Connect the fixture to the mains with the enclosed power plug.If you need to install other power plug on the power

cable,follow the identification table below.

The earth has to be connected!

The occupation of the connection-cables is as follows:

Cable (EU) Cable (US) Pin International

Brown Black Live L

Light blue White Neutral N

Yellow/Green Green Earth

Do not connect the projector to a dimmer system!

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

No comments

Robe COLORSPOT 170 AT Specifications Page 11