Robe CitySource 96 WDMX Specifications download pdf (Page 17)

CitySource 96 (RGBW)

DM.In.---DMX values. Select this function to read DMX values of each channel received by the fixture.

tEMP --- Fixture Temperatures. Select this menu to read the temperatures of the fixture:

Cur.t. --- the current temperature of the fixture inside.

Hi.tE. - the menu item shows the max. temperatures of the fixture inside since

the CitySource 96has been fabricated.

rSEt --- the menu item shows the maximum temperatures of the fixture inside since the counter

was last reset. In order to reset this counter to 0 you have to press and hold the UP and DOWN

buttons and at the same time press the ENTER button.

Note: The ambient temperature should not exceed 40°C.

Measuring points:

LEdS.--- the temperature of the LEDs module.

boAr. --- the temperature on the PCB in the fixture base.

The temperatures can be displayed in either °C or °F units - see option “tEM.U“ in the menu “Pers“.

VErS. ---Software Versions. Select this function to read the software version of the fixture processor.

6.3 Personality

Use this menu to modify the CitySource 96operating behaviour.

DM.Pr. --- DMX preset. Select this menu item to set a desired DMX mode. Please refer to the chapter "DMX

protocol" for detail description of each DMX mode.

DiSP. --- Display adjusting. This function allows you to change the display settings.

d.On --- this function allows you to keep the display on or to turn off automatically 2 minutes

after last pressing any button on the control panel.

d.Int. --- select this function to adjust the display intensity (20-min.,100-max.).

turn --- select this function to turn the display by 180°.

tEM.U. --- Temperature Unit. Use this menu in order to display the fixture temperatures in desired units: °C or °F.

bALA --- Balance Use this menu item to enable (On) or disable (Off) the white balance which is set in the “White

colour balance“ menu below. I f this function is set off, the CitySource 96will use maximum values (255) of

saturation for red, green and blue colour. This function has to be set on before adjusting a white balance.

C.bAL. --- White Colour Balance. The menu gives access to the setting of the white balance.

To set white colour balance.

1. Use a DMX controller or the “ Man.C.“ menu to set all LEDs on max. saturation.

2. Use the UP/DOWN buttons to find the “ Pers.“ menu.

3. Press the ENTER button.

4. Use the UP/DOWN buttons to select the “C.bAL“menu.

5. Press the ENTER button and the “rEd“ item will appear on the display.

6. Press the ENTER button and use the UP/DOWN buttons to set new max. value for the red LEDs.

7. Press the ENTER button to confirm the choice.

8. Use the UP/DOWN buttons to select next colour, the “GrEn“.

9. Repeat steps 6-7 for this channel.

10. Use the UP/DOWN buttons to select the last colour, the „bLuE“ and repeat steps 6-7 for this colour.

LoAd

--- Load of LEDs. The menu allows to choose 2 different operating modes for fixture´s LEDs.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

No comments

Robe CitySource 96 WDMX Specifications Page 17